Laser scribing Jig
MS Code: E002-1556

The Laser Scribing jig is used to allow for consistent alignment of glass substrates during the laser scribing cycle. Laser scribing jig is provided with the Large Laser Scribing System.

Product Details

The Laser Scribing jig uses a three pin alignment system to ensure that the glass substrates are placed in a repeatable position on the work table within the laser scriber. This allows for multiple substrates to be scribed during the one production run.

Specifications
Use : The Laser Scribing jig is used to allow for consistent alignment of glass substrates during the laser scribing cycle. Laser scribing jig is provided with the Large Laser Scribing System.
Consider :
  • Greatcell Solar pre-printed TEC8 & TEC15 Glass Plates
  • Greatcell Solar DSC Laboratory Solution

  • Specifications :
    FeaturesDescriptionBenefit / Additional Information
    Jig Size Length 600mm x Width 300mm, Height 6mm High precision control system puts you in charge
    Capacity Maximum  of 6 electrodes Multiple electrodes can be scribed during the one scribing cycle
    Substrate size: Maximum:    180mm x 100mm
    Minimum:    140mm x 60mm
    Dyesol standard glass plates can be accommodated using the standard configuration